DISINFECTION UNIT BASED ON KAMAZ (UD-E) CHASSIS

The disinfection unit mounted on an automobile chassis is designed for its intended use at temperatures from 0 °C to plus 30 °C, storage and transportation conditions at temperatures from minus 45 ° C to plus 40 °C.


INSTALLATION STRUCTURE

The installation consists of the following main parts:

The tank is 3 mm thick metal, divided into two compartments. The rear compartment contains cans of mother liquor.

The tank is made of metal, with a heater and a heat exchanger. To control the temperature of the working solution, a TKP-100EK-M1-UHL4 pressure gauge thermometer with a temperature sensor is installed.

Flare-type working solution heater 144.8106- 30 powered by the vehicle's on-board power supply. The heating capacity of the heater is 35 kW. The mother liquor heater (carried out through a heating element).

Plastic cans for the mother liquor (12 pieces of 25 liters each), metal cans can be supplied.

Manual pump PK-2.

Vortex pump VK 2/2,6.

The pump is driven by a KOM through a cardan shaft and a V-belt transmission.

Valve box, including pressure receiver, intake manifold and shut-off valves.

The pipeline system of the working solution.

A coil for pressure hoses.

A receiving hose with a length of at least 4.5 m and a nominal passage of 50 mm ± 2 mm designed to draw water from a reservoir.

A manual barrel with replaceable sprayers and a hose with a nominal passage of 15 mm ± 2 mm, a hose length of 15 m, designed to supply the working solution to the disinfection treatment site.

ZIP case with dimensions, mm (LxWxH) 310±WxDxH 10±3x46±3.


Hand-held barrel work:

1. Washing with a directed liquid jet:

- the length of the horizontally directed jet, at least 6 m at a pressure gauge of 0.3 MPa (3 kg/cm2);

- capacity (liquid consumption), 18 l/min;

- the temperature range is up to 50 °C.

2. Wet disinfection with directed aerosols:

- spray angle, 60°;

- capacity (liquid consumption) 12 l/min.


Work performed by stationary devices:

1. Site treatment with liquid jet:

- end devices for liquid supply - two slotted nozzles installed in the front of the carrier vehicle; the nozzles can be rotated and fixed in any position relative to two mutually perpendicular axes. The angle of rotation of the nozzles relative to the 90 ° axis;

- the total capacity (liquid consumption) of the nozzles is 40 l/min;

- the spray angle in the horizontal plane is 90°.

2. Volumetric treatment of rooms with aerosols:

- end devices for liquid supply - two aerosol dispensers installed in the rear of the carrier vehicle; the dispensers can be rotated and fixed in any position relative to two mutually perpendicular axes. The angle of rotation of the nozzles relative to the 90 ° axis;

- the total capacity (liquid consumption) of the sprayers is 20 l/min;

- the spray angle is 90°.