Self-propelled PT platforms

RT-type self-propelled platforms are used on construction sites to move bulky and heavy equipment, building materials, structural units, blocks and other cargo.
It is a self-propelled vehicle consisting of a cargo platform mounted on wheel blocks, which has the ability to lift / lower relative to the ground. Lifting/lowering is carried out using hydraulic cylinders installed between the loading platform and the wheel unit, the lifting height is 320 mm. The front and rear parts of the platform can be raised/lowered independently of each other. The number of wheel blocks can vary, depending on the load capacity, from 4 to 12 or more. The steering is mounted on each wheel unit, the front and rear wheels are controlled separately, which gives the car good maneuverability. On request, it is possible to install electronic steering, which allows you to perform maneuvers such as crab running, carousel running, turning the front / rear / all wheels. The platform is moved using hydraulic gear motors installed in the wheel blocks. The maximum climb in the standard version is 3%, the travel speed is up to 5 km/h.
The load capacity of a self-propelled PT type platform can range from 20 to 200 tons or more. The dimensions are determined based on the customer's requirements. The machines may be able to increase the size of the cargo platform in length and width using hydraulics, installing a turntable and other necessary devices.
In the standard version, the self-propelled platform is powered by a diesel engine using hydraulics. On request, it is possible to supply a car with a hybrid drive – both from a diesel engine and from a battery. At the same time, the battery can be charged both when the diesel engine is running and from a common network. The engine, fuel and oil tanks, hydraulic devices, and batteries are located in the engine compartment, which is located under the platform.
The control is carried out using a remote radio control or a wired emergency remote control. The car has a stationary panel on which the ignition key, mode switches, control devices and lamps are located.
A self-propelled RT-type platform has the ability, after lowering to the lower position, to drive under the load mounted on the stands, lift it, transport it to the right place and re-install it on the stands. In this case, no other lifting equipment is required.
If necessary, when moving particularly large loads, two or more self-propelled platforms can work together, being controlled from a single console.
All machines are designed and manufactured to meet customer requirements, so we have the opportunity to offer equipment for solving a wide variety of non-standard tasks. The PT self-propelled platform is a good solution for transporting various cargoes on production and construction sites.