TONAR SDP3-89 trailers and semi-trailers WITH SLIDING FLOORS, Krasnodar

Dimensions:
Length (internal dimensions), mm

13 660

Width (internal dimensions), mm

2 480

Height (internal dimensions), mm

2 634

Height of the coupling device, mm

1 150

Weight:
The weight of the loaded semi-trailer, not more than, kg

8 500

Weight of the transported cargo (technically permissible), kg

29 500

Load on the SSU, kg

11 000

Axial load, kg

27 000

Axes "Tonar":
Wheel axles

Tonar

Tires

Tubeless 385/65R 22.5

Pendant

dependent, on longitudinal elastic levers with pneumatic elastic elements and telescopic hydraulic shock absorbers

Lifting axle

the front

Other features
Back wall

aluminum swing gates

Side walls

made of aluminum profile

Paul

Cargo Floor sliding floor system

Body volume, cubic meters

89

Support device

for 24 tons
The sliding floor consists of a series of longitudinal aluminum beams that are hydraulically driven. The drive is three-section. Each section of the beams is powered by its own hydraulic cylinder. The beams perform reciprocating movements in the longitudinal direction. During unloading and loading, all sections of the beams move simultaneously (the beam stroke is 200 mm.). When the beams are reversed, the sections move alternately. Then the cycles repeat and the load moves. The time of full unloading is 15 minutes.

No risk of overturning of the semi-trailer during unloading, in comparison with semi-trailers with dump truck lifting. Loading and unloading takes place horizontally, relative irregularities are not dangerous, as well as unstable soils of unloading sites. Unloading can be carried out in rooms with a ceiling height not much higher than the actual semi-trailer (low warehouses, factory workshops, docks). Full control of the hydraulic structure from a manual remote control. The design of the sliding floor does not require any routine technical support during operation. The ability to load and unload without using a loader inside the body.