Trailers and semi-trailers TONAR SDP4-82 (82.6 cubic meters) WITH SLIDING FLOORS, Krasnodar

Dimensions:
Length of semi-trailer, mm

14 120

Width of the semi-trailer, mm

2 550

The height of the semi-trailer, mm

4 000

Height of the coupling device, mm

1 150 / 1 350

Weight:
The weight of the loaded semi-trailer, not more than, kg

10 390 / 11 300

Weight of the transported cargo (technically permissible), kg

40 000

Load on the SSU, kg

18 000

Axial load, kg

36 000

Axes "Tonar":
Wheel axles

Tonar

Tires

Tubeless 385/65R 22.5

Pendant

dependent, on longitudinal elastic levers with pneumatic elastic elements and telescopic hydraulic shock absorbers

Lifting axle

1 and 2 or 1 and 4

Other features
Back wall

swing gates

Side walls

sandwich panels with reinforced rigidity

Paul

Cargo Floor sliding floor system

Body volume, cubic meters

54,5 / 82,6

Support device

for 24 tons

Configuration options
Model
SDP-55

SSU
1 200 / 1 250


Semi-trailer type with sliding floors

The body
is made of sandwich panel

Volume
55 cubic meters

Number of axes
4

The type
of bushing is single-pitched

Pendant
lever type; Wabco pneumatic system

Awning
with mechanical drive, included in the basic package

The braking system
TEBS_E

Additional options
installation of unloading hatches
The sliding floor consists of a series of longitudinal aluminum beams that are hydraulically driven. The drive is three-section. Each section of the beams is powered by its own hydraulic cylinder. The beams perform reciprocating movements in the longitudinal direction. During unloading and loading, all sections of the beams move simultaneously (the beam stroke is 200 mm.). When the beams are reversed, the sections move alternately. Then the cycles repeat and the load moves. The time of full unloading is 15 minutes.

There is no risk of the semi-trailer tipping over during unloading, in comparison with semi-trailers with dump truck lifting. Loading and unloading takes place horizontally, relative irregularities are not dangerous, as well as unstable soils of unloading sites. Unloading can be carried out in rooms with a ceiling height not much higher than the actual semi-trailer (low warehouses, factory workshops, docks) Full control of the hydraulic structure from a manual remote control panel. The design of the sliding floor does not require any routine technical support during operation. The ability to load and unload without using a loader inside the body.